John Sayers' Recording Studio Design Forum
http://www.johnlsayers.com/phpBB2/

Wiring a 3.5mm Audio out jack where Speakers were previously
http://www.johnlsayers.com/phpBB2/viewtopic.php?f=12&t=21329
Page 1 of 1

Author:  zhizhuo [ Thu Nov 30, 2017 7:34 pm ]
Post subject:  Wiring a 3.5mm Audio out jack where Speakers were previously

Hi to all, After a few hours of effort, I admit I'm a little dizzy. :?: I'm stumped on this one. My monitor has these cruddy un-amplified speakers that you can barely hear when there is any other sound in the room you are in. My solution was to wire an audio out jack to replace the speakers. Below is how I changed the wiring:
Image
Before putting the final wiring in place I tested this configuration using my phone as the audio source connecting an aux cable with bare ends to the jack of the original cable http://www.kynix.com/Parts/3249163/CABLE.html, then plugging external speakers into the female port. Worked wonderfully. So i hook in the jack to the monitor, pack it all up, and play something on it. I get immense static over the speakers, and any volume past a certain point cuts out the audio altogether. My hunch is that twisting the two grounds together is what is causing this issue, but i'm not experienced enough with electronics to know how to resolve this.

Am I stuck with the original cruddy speakers, or is there a way to do this correctly?

EDIT: Also here is how I wired up the 3.5mm jack for reference
Image
EDIT 2: I have tried isolating one channel as others have suggested, this yielded the interesting result of preventing the cut-outs from audio peaks, but the intense static remained. I've also tried reversing what I assumed were left channel and ground, and that did not work.

I guess what I'm looking for most is that my logic with this correct? can you replace a stereo speaker output with an aux jack reliably? is this just a fringe result where it typically would be a success?

EDIT 3 (5-5-17):

Finally got a chance to wire it up how Trevor specified, still same issue, heavy static on the line through my amplified speakers, then I tried something that yielded an interesting result. in my frustration I figured I'd test the setup with a different speaker, just to see, but I only had a pair of headphones handy. I plug them in and nothing. Dead air. Through the speakers I get heavy static and distant speaking (no warble now that I've removed the two middle wires) but through the headphones I get dead silence. Maybe this is the clue that breaks the case?
Thank you read my question, any advice can help here.

Author:  Speedskater [ Thu Nov 30, 2017 11:48 pm ]
Post subject:  Re: Wiring a 3.5mm Audio out jack where Speakers were previo

Those two 'G' terminals may not be a common 'ground' connection (think about a bridged amp output). They may not be happy connected together.

Author:  Eric Best [ Thu Dec 07, 2017 7:36 am ]
Post subject:  Re: Wiring a 3.5mm Audio out jack where Speakers were previo

Unfortunately it isn't that simple. Probably the best thing to do is to find the signal before it goes into the amplifier for the speaker. By taking the output out after the power amplifier, you will have level and impedance matching problems.

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/