John Sayers' Recording Studio Design Forum

Hi Everyone

I am getting old and the neurons are dying fast , but I swear that yesterday I came across some very enlightening pictures of a partially completed floated studio floor with conduit skillfully positioned to deliver AC power to several locations in the room. I have read every entry in this forum and cannot locate the pix. Does this ring a bell for anyone?

Thank you for any suggestions (other than for me to take my medication and go to bed... ).

Also...I read a question about vapor barriers under a floated floor and wanted to mention that I sealed by cement floor with "Miracle Glaze", a water curing (single component) polyurethane coating that contractors use for commercial buildings. It is a Diamond Vogel product. My reasons for doing it this way were:

1. Minimize wood damage due to water vapor, and
2. Avoid the slippage encountered with plastic sheeting material.

Hope this was not a giant mistake!!

Eric

Would it have been somewhere in Aaron's studio thread?

http://www.johnlsayers.com/phpBB2/viewtopic.php?t=839

It's somewhere in one of the 27 pages I'd bet.

_________________
SaM Harrison
Location Engineers
Nashville, TN

The pix start around page 10 or 11 and go from there...