John Sayers' Design Forum

John Sayers' Recording Studio Design Forum

A World of Experience
Click Here for Information on John's Services
It is currently Mon Dec 16, 2019 7:06 am

All times are UTC + 10 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Mon Jun 24, 2019 7:31 pm 
Offline

Joined: Sun Jun 04, 2017 1:08 pm
Posts: 16
Location: Adelaide, South Australia
Hi all, in the planning for phase for the acoustic treatment of my rehearsal room

Room specs:
Rehearsal Inside dimensions: 4800mm (width) x 5900mm (length) x 2400mm (height)
Door placement: 4800mm wide wall in corner
Floor construction: 22mm chip board on rafters over dirt
Inner wall construction (working inside to outside): 9mm drywall/gyprock | 75mm R2.5 insulation | tin
Outer wall construction (working inside to outside): 75mm R2.5 insulation | axon scyon concrete sheets (9mm thick) mass =12.5kg2
Roof construction: 75mm R2.5 insulation | 9mm drywall/gyprock | tin

I am using the room for a rock band. Live drums, guitar and bass. The sound insulation is pretty good with only a quick test and no neighbor complaints yet...but the room sound like crap.

It is a box, with no treatment yet. I plan to put some rugs down for aesthetics, but what I am seeking advice on is how to treat the walls, corners, ceiling etc.

Currently I have the drums in the middle of the short wall (the wall without the door), shooting right down the centre, and the amps in the middle of the room pointing back at the drums.

On the other short wall I have a "recording setup" of computer desk, cheap speakers....that is SECONDARY to the live room, but it would be still nice to have this sounding a bit better too.

Any thoughts, material suggestions, baffle sizes specific to the size of the room would be great.

I am pretty handy with tools so will do all the building myself. My budget is around $2,000

Thanks in advance


Report this post
Top
 Profile  
 
PostPosted: Mon Jun 24, 2019 11:05 pm 
Offline

Joined: Tue Mar 25, 2008 3:31 am
Posts: 173
Location: Cork Ireland
Unfortunately the two biggest surfaces in your room are reflective and parallel. Floor and ceiling.
Treat the ceiling extensively to a depth of at least say 8". This is typically done using commercial batt traps by RealTraps, GIK, etc.
I would tend to not go DIY for overhead. One doesn't want LF shaking those fibres into descent.
Look up Clouds. A suspended ceiling as seen in offices and such can be a very cost effective way to do this. Use absorbent only tiles (many of them have a blocking layer). Fill the void above them with light fibre.
DD


Report this post
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group